By default ConditionFirstBoot is ankered to the presence of
/etc/machine-id. However, in our case /etc/machine-id is a bind mount,
which makes the first boot condition non-working.
Since machine-id is stored by the bootloader on HAOS, use the boot
loaders knowledge and pass the information to systemd.
* Support custom sized SPL/raw boot region
This is required for Rockchip which by default stores the U-Boot FIT
image at the 8MiB offset.
* Ignore shellcheck warning
The new systemd version v252 brings a new naming scheme, in particular
it seems that on device tree based systems (e.g. Raspberry Pis) the
Ethernet device name changes from eth0 to end0.
This breaks a previously made configuration.
Even worse, it seems that the default NetworkManager behavior is to only
configure a network device if there is no profile. But since profiles
are configured on a typical installation, NetworkManager doesn't bring
up any of the network interface, leaving the user stranded on an
unconnected system.
Ideally, we should have a plan how to migrate from one naming scheme to
the next. For now, just stick with the naming scheme HAOS 9.x has been
using.
The cgroup_enable parameter is a Raspberry Pi kernel specific kernel
parameter. Upstream based kernel do not have the parameter, and hence
do not do anything.
This gets rid of the following message during boot:
Unknown kernel command line parameters "cgroup_enable=memory", will be passed to user space.
* Retry up to 3 times
By default, HAOS used to retry 3 times. That is still true for U-Boot
based boards. Apply the same logic for GRUB2 based systems for
consistency.
This can help to remedy intermittent internet/connectivity issuese.
Altough hacky, in practise it makes sense to give the newly installed OS
another go.
* Also apply to generic-aarch64
This aligns with what we used to have in Barebox. Most of the time the
user is not expected to make a choice, so keeping the timeout short is
sensible.
* Add AArch64/ARM64 EFI boot support (for QEMU and some boards)
* Allow GRUB to load cmdline.txt-like
* Enable qcow2/vmdk disk images
Co-authored-by: Stefan Agner <stefan@agner.ch>
