By default ConditionFirstBoot is ankered to the presence of
/etc/machine-id. However, in our case /etc/machine-id is a bind mount,
which makes the first boot condition non-working.
Since machine-id is stored by the bootloader on HAOS, use the boot
loaders knowledge and pass the information to systemd.
* Support custom sized SPL/raw boot region
This is required for Rockchip which by default stores the U-Boot FIT
image at the 8MiB offset.
* Ignore shellcheck warning
The new systemd version v252 brings a new naming scheme, in particular
it seems that on device tree based systems (e.g. Raspberry Pis) the
Ethernet device name changes from eth0 to end0.
This breaks a previously made configuration.
Even worse, it seems that the default NetworkManager behavior is to only
configure a network device if there is no profile. But since profiles
are configured on a typical installation, NetworkManager doesn't bring
up any of the network interface, leaving the user stranded on an
unconnected system.
Ideally, we should have a plan how to migrate from one naming scheme to
the next. For now, just stick with the naming scheme HAOS 9.x has been
using.
* RaspberryPi: Update kernel 5.15.61 - 1.20220830
* Add Yellow to the Raspberry Pi kernel update script
* Bump Yellow to kernel 5.15.61 - 1.20220830
Also drop the work around for the LED polarity as the new firmware
has been fixed.
* Explicitly select no kernel module compression
Home Assistant OS uses a compressed rootfs already, no compression for
kernel modules necessary.
* Bump buildroot
* buildroot d7e4c223e5...5468d36a26 (1):
> package/rpi-firmware: bump version to 1.20220830
This makes the Red+Blue Button cause the boot loader to wipe start4.elf,
which is essential for the boot loader to boot from eMMC. With the file
missing, the Raspberry Pi firmware will continue its boot flow and boot
from USB host next. This allows to run the Home Assistant OS Installer
from a USB flash drive again.
* Enable additional LED triggers
* Improve Yellow device tree
Fix soundcard name and use BTN_1 as key code.
* Add input-event-daemon configuration
Add minimal input-event-daemon configuration to avoid the default
configuration taking effect. This minimal configuration triggers
the USB configuration import on button press.
* Fix enable USB host mode kernel patch
Update to a new patch which applies the device tree change such that the
USB controller actually gets enabled.
* Update Home Assistant Yellow board config
Update config to match changes which have been made to other baords as
well.
* Rename Home Assistant Amber to Yellow
Rename the board from "amber" to "yellow" as Home Assistant Yellow is
the official name now.
* Add Home Assistant Yellow to the build matrix
