* add eq3_char_loop package (eQ-3 char loopback kernel module)
* add generic_raw_uart package (low-latency raw UART kernel driver)
* add rpi-rf-mod package
* add device tree overlay support for RPI-RF-MOD/HM-MOD-RPI-PCB on Raspberry Pi
* enable GPIOLIB and GPIO_SYSFS required for RPI-RF-MOD/HM-MOD-RPI-PCB support.
* add basic RPI-RF-MOD/HM-MOD-RPI-PCB support for ASUS Tinker Board
* add device tree overlay support for ASUS Tinker Board and add
haos-config.txt loading support to U-Boot boot script
* Add SocketCAN support
A Controller Area Network (CAN bus) is a robust vehicle bus standard designed to allow microcontrollers and devices to communicate with each other's applications without a host computer. It is a message-based protocol, designed originally for multiplex electrical wiring within automobiles to save on copper, but it can also be used in many other contexts. For each device, the data in a frame is transmitted sequentially but in such a way that if more than one device transmits at the same time, the highest priority device can continue while the others back off. Frames are received by all devices, including by the transmitting device.
* Update also for GS_USB support
There is a port of the candleLight USB to CAN firmware for CANable. The port works very well under Linux using the gs_usb driver. This firmware does not use slcan, so it is not interchangeable with the stock firmware. However, the CANable appears as a CAN interface natively in Linux
With the candlelight firmware, simply plug in the CANable and the device will enumerate as can0. Set the baud rate and bring the interface up with the following command, and you're good to go!
ip link set can0 up type can bitrate 500000
* Update for Peak PCAN-USB Support
* Enable hidraw driver (#1120)
The hidraw driver is required by some IoT devices such as Wyze sense or
Jablotron JA-100. Enable the driver on all platforms by default.
* Update azure-pipelines-release.yml for Azure Pipelines
* Update azure-pipelines-release.yml for Azure Pipelines
* Update azure-pipelines-release.yml for Azure Pipelines
* Fix double LINUX_HEADERS
* Add support for TI USB 3410 or 5052 serial devices (#542)
* Added BT support to device-support.conf file, and removed BT support from kernel.config file
* Removed BT support, as it was moved to device-support.config file
* Added new line at the end of the file
* Changed:
CONFIG_BT_HCIBTUSB from 'm' to 'y'
CONFIG_BT_HCIBTUSB_BCM from 'y' to 'm'
CONFIG_BT_HCIBTUSB_RTL from 'y' to 'm'
* Update device-support.config
Co-authored-by: Pascal Vizeli <pascal.vizeli@syshack.ch>
Working:
* Ethernet
* Resize of Data
* RAUC boot marking/fetching
* CMD Line into HASSOS and Linux
Partially working:
* USB (requires 1+ devices in at boot. Seems to be a kernel/dt issue.)
Untested:
* RAUC Update
* HDMI
Not working:
* Homeassistant
** We see:
hassio > ha info
The HTTP request failed with the error: Get http://hassio/homeassistant/info: dial tcp 172.30.32.2:80: getsockopt: connection refused
