It seems that the crash of the Meson DRM driver on shutdown can also be
fixed by compiling it in. The driver is also built-in in LibreELEC,
hence this is better tested by the upstream community.
Note the underlying issue seems to be a disabled clock: Since the
introduction of meson_drv_shutdown some registers are touched at a very
late stage. Those clock get disabled in meson_ee_pwrc_shutdown. It seems
that when the driver is built-in, meson_drv_shutdown gets called before
meson_ee_pwrc_shutdown and hence sidesteps the problem.
Note: This increases the kernel by a bit since DRM needs to be built-in
as well. Configure some less common used file systems as modules
(ext3/NFS).
* Add Ralink rt27xx/rt28xx/rt30xx firmware (#1242)
Add Ralink firmware for devices which have the driver enabled. The
firmware's are rather small at 20KiB in total.
* Remove Ralink and other WiFi drivers from Tinker Board
The board has on-board WiFi, no need for Ralink drivers to be enabled.
* Add Ralink WiFi drivers and firmware to ODROID boards
* Add Realtek RTL8812AU out-of-tree driver
This adds support for Realtek RTL8812AU devices such as the Hardkernel
WiFi Module 5A (with the RTL8811AU chipset, supported by this driver as
well). This patch uses Realtek driver 5.9.3.2 which has been made to
compile up to Linux 5.10.
Note: This driver does not seem to support 5GHz networks! But it seems
the only driver which supports the RTL8811AU chipset and also works with
recent mainline drivers...
* Enable RTL8812AU driver for Hardkernel modules
The WiFi Module 5A comes with a RTL8811AU chipset. Enable the driver for
all Hardkernel modules.
