By default ConditionFirstBoot is ankered to the presence of
/etc/machine-id. However, in our case /etc/machine-id is a bind mount,
which makes the first boot condition non-working.
Since machine-id is stored by the bootloader on HAOS, use the boot
loaders knowledge and pass the information to systemd.
* Support custom sized SPL/raw boot region
This is required for Rockchip which by default stores the U-Boot FIT
image at the 8MiB offset.
* Ignore shellcheck warning
The new systemd version v252 brings a new naming scheme, in particular
it seems that on device tree based systems (e.g. Raspberry Pis) the
Ethernet device name changes from eth0 to end0.
This breaks a previously made configuration.
Even worse, it seems that the default NetworkManager behavior is to only
configure a network device if there is no profile. But since profiles
are configured on a typical installation, NetworkManager doesn't bring
up any of the network interface, leaving the user stranded on an
unconnected system.
Ideally, we should have a plan how to migrate from one naming scheme to
the next. For now, just stick with the naming scheme HAOS 9.x has been
using.
The cgroup_enable parameter is a Raspberry Pi kernel specific kernel
parameter. Upstream based kernel do not have the parameter, and hence
do not do anything.
This gets rid of the following message during boot:
Unknown kernel command line parameters "cgroup_enable=memory", will be passed to user space.
* Remove duplicate config.txt copy statement
* Use static cmdline.txt file
Instead of dynamically creating cmdline.txt use a static version of it.
This aligns with other boot loader/firmware configuration files and makes
it easier to customize the file per board.
* Add squashfs with LZ4 and LZO compression to Barebox
* Add squashfs with LZO compression to U-Boot
* Use squashfs for Linux kernel partition
Generate a squashfs image with LZO compression for the Linux kernel
partition. Adjust the boot scripts to be file system independent commands
to boot from squashfs.
* Revert "Fix boot from 128GB Micron eMMC on ODROID-N2(+) (#1064)"
This reverts commit 162084082e.
This patches seem to cause issue on a ODROID-N2 with 32GB eMMC.
* Cap eMMC frequency to 24MHz in U-Boot for ODROID-N2(+)
Also remove the ODROID-C4 specific patch.
* Avoid trying to boot non-existing kernel image in fail-over case
The A/B update system automatically switches to the other boot slot when
booting fails. However, in a fresh installation, only boot slot A
exists. If booting fails three times (e.g. if somebody plugs out power
before the slot can be marked as good), then the system switches to boot
slot B which does not contain a kernel image yet. Avoid trying to boot
the non-existing kernel image.
With this change, if slot B is empty U-Boot will restore both slots to 3
attempts and retry booting from slot A on next reboot:
```
Trying to boot slot B, 2 attempts remaining. Loading kernel ...
** Unrecognized filesystem type **
No valid slot found, resetting tries to 3
storing env...
```
Co-authored-by: Pascal Vizeli <pascal.vizeli@syshack.ch>
* Fix N2+ boot by disabling USB enumeration
On some devices USB enumeration in U-Boot seems to freeze:
starting USB...
Bus usb@ff500000: Register 3000140 NbrPorts 3
Starting the controller
USB XHCI 1.10
scanning bus usb@ff500000 for devices... <freeze>
We don't use USB currenty in the U-Boot script, disable it for now.
* Disable USB enumeration on all ODROID devices
