The bump to U-Boot 2021.10-rc5 also makes quite some patches obsolete
since they are already part of U-Boot.
This also removes a patch which disables framebuffer support on
Raspberry Pi: Framebuffer support seems to work fine in todays
U-Boot/Linux combination. It can help debug boot problems on Raspberry
Pi devices. Without the patch framebuffer support will be enabled by
default.
* Re-add patches missed with U-Boot 2021.04-rc4 upgrade
Also add patches for Raspberry Pi again.
* Regenerate patches for U-Boot 2021.04
* Update to U-Boot 2021.04
Bump to the latest U-Boot release 2021.04-rc4. This alows to drop quite
some patches which have been sent to the mailing list or picked from the
mailing list and have been merged upstream now.
* Revert "Fix boot from 128GB Micron eMMC on ODROID-N2(+) (#1064)"
This reverts commit 162084082e.
This patches seem to cause issue on a ODROID-N2 with 32GB eMMC.
* Cap eMMC frequency to 24MHz in U-Boot for ODROID-N2(+)
Also remove the ODROID-C4 specific patch.
The version banner was showing "Amlogic Meson G12A (Unknown) Revision
28:0 (0:0)" in all cases instead of the correct SoC name and revision.
Make sure the SoC revision is properly read also for the banner.
* Make sure to set board_rev for N2+ correctly
For some reason the code to set the environment did not make it into the
ODROID N2 board code. Fix the patch to correctly set board_rev for N2(+).
Also remove the w400 patch as it is no longer required.
* Use latest ODROID-N2+ patches
Use the queued patches (and fixes) for upstream ODROID-N2+ support.
This uses the clock settings from meson-g12b-a311d.dtsi running the
CPUs at the following clocks:
- 4xA73@2.2GHz
- 2xA53@1.8GHz
Remove code duplication and make sure to load socinfo only once. Also
set board_rev before MAC address to make sure board_rev is set even if
loading MAC address from efuses fails.
