After running HAOS on my ODROID N2+ several hours I see freezes and
sometimes stack traces which point to a problem in CPU frequency
scaling. This crash seems not to appear on Hardkernel's 18.04 Ubuntu
stable release. However, Hardkernel's Ubuntu uses the performance
governor. Use the performance governor as well to avoid crashes on N2+.
* Use latest ODROID-N2+ patches (partial #929)
Use the queued patches (and fixes) for upstream ODROID-N2+ support.
This uses the clock settings from meson-g12b-a311d.dtsi running the
CPUs at the following clocks:
- 4xA73@2.2GHz
- 2xA53@1.8GHz
* Actually fix CDC ACM error recovery path (#921)
Remove the revert of the cool-down patch and add the actual fix for
the CDC ACM error recovery path.
Revert CDC ACM cool-down patch. This should fix the error recovery paths
in the CDC ACM driver and allow CDC ACM devices to continue working even
in the event of USB issues.
The patch causes U-Boot freezes in some configurations. The root cause
is that U-Boot does not allow to use the bss section in pre-relocation
code (which is where the UART is used). Drop the patch as it is not
required currently.
See also:
http://u-boot.10912.n7.nabble.com/RPi4-U-Boot-freeze-td424432.html#a427198
The to symlink serial0/1 currently might apply to the first or second
ttyAMAX instance. In downstream, a patch makes sure that the first
PL011 is always ttyAMA0. However, upstream the numbering depends on the
UART alias, which leads to the first PL011 being ttyAMA1.
Check the actual iobase too to make sure we are dealing with the first
PL011 instance.
See also:
05cfe136f7 (diff-2678c183f503319c8d8c09c818af789a)
Remove code duplication and make sure to load socinfo only once. Also
set board_rev before MAC address to make sure board_rev is set even if
loading MAC address from efuses fails.
* Add ODROID-N2+ support
Add ODROID-N2+ support with the new SoC revision c. Extend the U-Boot
script: Assume ODROID-N2 if the SoC revision is "a" (there are only "a"
revision SoCs on ODROID N2) and assume N2+ otherwise.
Currently using overclock mode as proposed in the upstream kernel patches.
* Update hassos-hook.sh
Co-authored-by: Pascal Vizeli <pascal.vizeli@syshack.ch>
* Update azure-pipelines-release.yml for Azure Pipelines
* Update azure-pipelines-release.yml for Azure Pipelines
* Update azure-pipelines-release.yml for Azure Pipelines
* Fix double LINUX_HEADERS
* Add support for TI USB 3410 or 5052 serial devices (#542)
* Added BT support to device-support.conf file, and removed BT support from kernel.config file
* Removed BT support, as it was moved to device-support.config file
* Added new line at the end of the file
* Changed:
CONFIG_BT_HCIBTUSB from 'm' to 'y'
CONFIG_BT_HCIBTUSB_BCM from 'y' to 'm'
CONFIG_BT_HCIBTUSB_RTL from 'y' to 'm'
* Update device-support.config
Co-authored-by: Pascal Vizeli <pascal.vizeli@syshack.ch>
